![]() ![]() I did an upload again and it shows me - Communicatin aborted LCD5500ZVersion 3.1-3.2 module is not responding. System found Keypad 01, Keypad 08, zones 9-12 and zones 13-16. Then I read the installer manual section 2.8 it says, do 902, wait for a minute or so then do 903. Programming worksheets PC 5010 ver 2.0 I tried doing the 8 installer code, it asks for section and i punch in 902 and it keeps asking for section. You give the zones zone types (appropriate for what you want them to do) in programming locations 001 and 002, and you make sure they are active in partition 1 in programming locations 202 and 203.Īs you may have noticed, even with the software, you still need to read the manual to understand the terminology.ĭSC Power 832 PC5010 Ver 2.0 DLS-3 version 1.3 or later 2. How can I enable 8 thru 16 and then clean up the escort module so that it wont show as failure.Ĭurrently the upload shows Communication Aborted The module is not responding, it is likely that the module has not been enrolled on the system LCD 5500 Z VERSION 3.1 3.2 Thanks. I think the programming still thinks that the escort module is still there. I have uploaded the information from the 5010 and printed it to a pdf file. You need both books, the installer manual makes no sense without referring to the programming worksheets. Most of the questions you are asking are explained in section 5.8 of the manual. I assume that you already have the installer manual and programming workbook. ![]() If the panel has never been downloaded by the software these will generally be left at the default. The default installer, download, and panel ID are all 5010 on one of these. If you really want to try to program this thing with the software, you want to go with the PC link cable. Yes, the installer code and the master code are two different things. USB adapter for this- in an earlier post someone was asking which adapter to use- iam not sure about mine- got 2 from e-bay, and both worked- 2 different brands- from china NO- master code DL code are not the same- unless thats what they programmed- they are 2 dif codes in programming, but can be the same goto DSC site, they may have it there- it may be on this site too iam sure RON will add to this- he knows where they are located look at old post on here to see if its said where. YES- you can connect- there is a series of 4 pins on the board - this is where you connect the PC-link cable that is also made by DSC- it uses a 9 pin serial connector on the computer end. Go it Where can I download a programming manual for 5010 Thanks. Is the downloading access code is same as the master code for the panel 3. Dsc Dls Iv Software Serial Connector On.Dsc Dls Iv Software Download Answer Enabled. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |